NJ Zoning Check

Franklin (Gloucester) zoning check

Enter your address to find your zone and see if your project fits. No account needed.

About these numbers

Enter a lot with a house in Franklin Township and see, line by line, whether a house, addition, shed or detached garage meets the Township's lot, yard, coverage and height limits.

Covers the Township of Franklin's single-family zones R-A, MDR and FV, Gloucester County. Checks a new house, an addition, an attached garage or a detached garage or shed.

Numbers last checked November 16, 2026 against the Township's Chapter 253, Sections 253-107, 253-117 and 253-131.

Check a different address

We send the address to New Jersey's public parcel records and public zoning maps to find your lot. Privacy

Know your zone? Leave the address blank.Detailed check for architects and contractors

What you can build in Franklin (Gloucester)

Franklin (Gloucester) has 3 single-family zones covered here: R-A, MDR and FV. Minimum lot sizes run from 30,000 sq ft (MDR) to 65,340 sq ft (R-A). A house must sit 10 ft (FV) to 75 ft (R-A) back from the street and 20 ft (FV) to 50 ft (R-A) from the rear lot line. Houses can be up to 35 ft tall in most zones. Buildings may cover up to 25% of the lot in the zones that set one (MDR).

New house or addition

Depends on your zone. Your address will show your exact numbers.

From the street
10 to 75 ft
From each side
8 to 20 ft
From the back
20 to 50 ft
Height
35 ft
See the limits for every zone
ZoneFrontEach sideRearHeightAll buildings togetherImpermeable surface
R-ALots of 65,340 sq ft75 ft20 ft50 ft35 ft——
MDRLots of 30,000 sq ft50 ft15 ft50 ft—25%—
FVLots of 30,000 sq ft10 ft8 ft, 20 ft total20 ft35 ft, 2.5 stories—50%
  • A dash means this check has no limit for that item.
  • Coverage is a share of the lot.

Sheds and detached garages have their own rules. Enter your address above to see them.

Standard limits for single-family lots. Corner lots and special rules can change them. Last checked November 16, 2026. Confirm with the town before you design or buy.

Franklin (Gloucester) zoning questions

What are the setbacks in Franklin (Gloucester), NJ?

For a single-family house. Corner lots can differ.

  • R-A: 75 ft from the street, 20 ft on each side, 50 ft from the rear line.
  • MDR: 50 ft from the street, 15 ft on each side, 50 ft from the rear line.
  • FV: 10 ft from the street, 8 ft on each side (20 ft in total), 20 ft from the rear line.

What is the minimum lot size in Franklin (Gloucester)?

R-A: 65,340 sq ft; MDR: 30,000 sq ft; FV: 30,000 sq ft.

How tall can a house be in Franklin (Gloucester)?

R-A: 35 ft; FV: 35 ft, 2.5 stories.

How much of my lot can I cover in Franklin (Gloucester)?

MDR: 25% building coverage; FV: 50% lot coverage.

Can you recommend an architect in Franklin (Gloucester)?

Yes. Tell us about your project and we'll connect you with a vetted, licensed residential architect who works in Franklin (Gloucester). It's free and there's no obligation.

We'll connect you with a vetted, licensed residential architect who works in Franklin (Gloucester) and can turn what your lot allows into drawings for your permit. Free, with no obligation.

Get a free architect referral

Zoning table for your drawings

ITEMREQUIREDEXISTINGPROPOSEDCOMPLIES

ENC = existing nonconforming condition, not increased. * = relief required.

Prepared with a calculation aid. Not a zoning determination. Confirm every requirement with the municipal zoning officer.

What this does not check

Where the numbers come from

Requirements were entered on November 16, 2026 from the Township of Franklin's Chapter 253, Land Development, Sections 253-107, 253-117 and 253-131. Check every requirement against the current code before relying on it.

A calculation aid, not a zoning determination. Using this site means you agree to the terms of use; see also the privacy policy.

Pick a zone to startSee the table