NJ Zoning Check

Kenilworth zoning check

Enter your address to find your zone and see if your project fits. No account needed.

About these numbers

Enter a lot in Kenilworth's R-6 or R-5 zone and see, line by line, whether a house or addition meets the Borough's lot, yard, height, coverage and floor area limits.

Covers the Borough of Kenilworth's single-family zones R-6 and R-5, Union County. Checks a new house, an addition or an attached garage.

Numbers last checked November 11, 2026 against Sections 120-23.1 and 120-23.2 of the Borough's code and its bulk standards sheet.

Check a different address

We send the address to New Jersey's public parcel records and public zoning maps to find your lot. Privacy

Know your zone? Leave the address blank.Detailed check for architects and contractors

What you can build in Kenilworth

Kenilworth has 2 single-family zones covered here: R-6 and R-5. Minimum lot sizes run from 5,000 sq ft (R-5) to 6,000 sq ft (R-6). A house must sit 25 ft back from the street and 20 ft from the rear lot line. Houses can be up to 35 ft tall. Buildings may cover up to 50% of the lot.

New house or addition

Depends on your zone. Your address will show your exact numbers.

From the street
25 ft
From each side
5 to 8 ft
From the back
20 ft
Height
35 ft
See the limits for every zone
ZoneFrontEach sideRearHeightAll buildings togetherEverything paved or built
R-6Lots of 6,000 sq ft25 ftVaries20 ft35 ft, 2.5 stories50%75%
R-5Lots of 5,000 sq ft25 ftVaries20 ft35 ft, 2.5 stories50%75%
  • Varies means the limit depends on details of your lot. Check your address to see what we can work out.
  • Coverage is a share of the lot.

Standard limits for single-family lots. Corner lots and special rules can change them. Last checked November 11, 2026. Confirm with the town before you design or buy.

Kenilworth zoning questions

What are the setbacks in Kenilworth, NJ?

For a single-family house. Corner lots can differ.

  • R-6: 25 ft from the street, 8 ft on each side, 20 ft from the rear line.
  • R-5: 25 ft from the street, 5 ft on each side, 20 ft from the rear line.

What is the minimum lot size in Kenilworth?

R-6: 6,000 sq ft; R-5: 5,000 sq ft.

How tall can a house be in Kenilworth?

R-6: 35 ft, 2.5 stories; R-5: 35 ft, 2.5 stories.

How much of my lot can I cover in Kenilworth?

R-6: 50% building coverage, 75% lot coverage; R-5: 50% building coverage, 75% lot coverage.

Can you recommend an architect in Kenilworth?

Yes. Tell us about your project and we'll connect you with a vetted, licensed residential architect who works in Kenilworth. It's free and there's no obligation.

We'll connect you with a vetted, licensed residential architect who works in Kenilworth and can turn what your lot allows into drawings for your permit. Free, with no obligation.

Get a free architect referral

Zoning table for your drawings

ITEMREQUIREDEXISTINGPROPOSEDCOMPLIES

ENC = existing nonconforming condition, not increased. * = relief required.

Prepared with a calculation aid. Not a zoning determination. Confirm every requirement with the municipal zoning officer.

What this does not check

Where the numbers come from

Requirements were entered on November 11, 2026 from Sections 120-23.1 and 120-23.2 of the Borough of Kenilworth's land use code, as shown in a published copy of the code, and compared with the Borough's Residential Zones Bulk Standards sheet. The sheet carries no date. Check every requirement against the current code, including any later ordinances, before relying on it.

A calculation aid, not a zoning determination. Using this site means you agree to the terms of use; see also the privacy policy.

Pick a zone to startSee the table